LAN speed problem when using non-default subnet

Discussion in 'DD-WRT Firmware' started by phatrabt, Sep 21, 2005.

  1. phatrabt

    phatrabt Network Guru Member

    Hi all, just noticed that when I'm doing transfers on my LAN I only get 1.2 Mb\s. I troubleshot and found that if I put the router back to the original subnet (192.168.1.x) my LAN transfers were back to the normal 80Mb\s. Can anyone else test this out to confirm? I was using 192.168.2.x as my subnet.
  2. 4Access

    4Access Network Guru Member

    Just ran a test on my 192.168.10.x network and got over 83Mbps...

    I doubt the subnet is the cause of the problem. Have you tried setting it back to 192.168.2.x and testing again?
  3. phatrabt

    phatrabt Network Guru Member

    I'll check again as soon as I can and post back. Thanks for testing it for me!
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice