Limit bandwidth to all internal IP addresses

Discussion in 'DD-WRT Firmware' started by desp59, Nov 28, 2007.

  1. desp59

    desp59 LI Guru Member

    I have a Comcast cable line connected to a few Linksys WAPs, and there are users who are flooding out the entire line with P2P networking I would assume and the line is extremely slow at times. I need to be able to limit each internal IP address to only take up a portion of the line. I was basically thinking since the line is 6000/1000, I would limit each IP address to a max of 750/150 or something like that. For the line to flood, a lot of people would have to be doing things they should not be doing. Monitoring would be nice, but it is not required. Is this something DD-WRT can do easily with a Linksys WRT54GL? Anyone have experience on how I could accomplish this? Thank you!
     
  2. u3gyxap

    u3gyxap Network Guru Member

    DD-WRT has a paid "special" version, which does exactly what you want.
    Other than that - the free tool Robson's WRT54G script generator will generate you a firewall script, which will do the same thing, with any 3d party firmware.
    You should also enable QoS.
     
  3. desp59

    desp59 LI Guru Member

    I have the paid version of DD-WRT. It allows to enter a netmask which I did 192.168.1.0/24 and then it only lets me put in a max Kbits. What is this value? Does it limit the enter subnet to that value, or does it limit each IP address to the value? So if I have 5 people connected and that value is 150 kbits, does each get 30 for a total of 50 or do each get 150 for a total of 750?

    Also, the script is nice but it only allows for 32 internal IP addresses and I am not exactly sure how to edit the script for the entire internal subnet.

    Can anyone help out here? Thank you!!!
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice