Linksys AG214 Configuration

Discussion in 'Other Linksys Equipment' started by krazykev, Dec 21, 2010.

  1. krazykev

    krazykev Networkin' Nut Member

    Hi all,

    I hope you can help me. I know what I want can be done as I did it in my previous office. That has since had an upgrade to VDSL and want to re-use my AG241 but had to reset the unit owing to a forgotten password.

    I have a small range of public IPs from my ISP, who allocate them to my devices in order. Let's say I have 111.222.333.001 to 111.222.333.010

    I want the Linksys AG241 to connect and obtain 111.222.333.010. I then want my firewall to request an IP and subsequently get 111.222.333.009 (they are allocated in reverse order).

    My experimenting has led me to a couple of questions?

    If I put the AG241 in 'bridge only mode' how do I connect to the web interface - does it retain its private IP for web administration?

    To get the config above I assume I need to use PPPoA on the AG241 so it gets an IP? Then how do I configure the firewall (obviously a question to ask elsewhere but am I right in thinking that would be a firewall configuration problem or should the AG241 get the second public IP on its behalf?)

    Hope that makes sense.

    Thanks all

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice