Linksys SRW248G4 and multiple membership in VLANs

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by skurg, Jun 27, 2012.

  1. skurg

    skurg Serious Server Member

    I can't figure out how to configure a port membership with multiple VLANs. My setup:
    - VLAN10
    - VLAN20
    - port settings tab: port24 in general mode
    - ports to VLANs tab: untagged everywhere, when I set port 24 membership to VLAN10 I can't set port 24 membership in VLAN20 because when I do that port 24 membership in VLAN10 dissapears and vice versa
    - but I can set port 24 membership to both VLANs in VLANs to port tab, but I think it doesn't work because:
    - when I connect hosts to ports 23 (port 23 is a member of VLAN10 only) and 24 there are not any connectivity between them, both ports membership is VLAN10
    - but connectivity is working when I set the same PVID for both ports 23 and 24 in port setting tab, I can't set multiple PVID in here.
    So, is it possible to configure port membership for multiple VLANs on this linksys?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice