1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Linksys WAG200G Problem

Discussion in 'Networking Issues' started by Phillis, Jun 20, 2007.

  1. Phillis

    Phillis LI Guru Member

    Currently, we have around 200 Linksys WAG354G’s in operation in the UK. All of these are working perfectly fine using the DHCP relay option.

    We recently got told these devices were discontinued, and were recommended by Broadband Buyer to opt for the WAG200G.

    I have just tried getting these to work using the same settings as we used on the WAG354Gs, but with no success.

    I can get a WAN address fine, but when I look under ‘Local Network’ on the ‘Status’ tab, although it says DHCP Relay, the start address starts with, whereas it should be getting the IP range from our DHCP server.

    Are you aware of the solution to this problem or is there any trial firmware that you are aware of that could fix this problem?

Share This Page