Linksys WET 54g v1.1 - power LED blinking - solution

Discussion in 'Other Linksys Equipment' started by DocPL, Dec 26, 2006.

  1. DocPL

    DocPL LI Guru Member

    Hello everyone.
    This is my first post here.
    Well, I play with linksys devices since 2003 including my WET 54G v.1.1
    This wireless bridge (especially versions 1.x) can cause a lot of problems. Well known issue is "Power led blinking - bridge turns on and off" This situation could ve been met with firmware 1.06, the new firmware 2.06 is supposed to eliminate that bug. However I flashed my bridge to 2.06 EU and after some time experienced this issue again.
    Simple reflashing with 2.06 EU did not help. This is what I have done to bring my WET back to life.
    1) flash to 2.06 EU - reset (if not working go to point 2)
    2) flash to 2.06 US -> reset -> flash to 2.06 EU -> unplug power cord -> press reset button for approx 60sec -> plug in power cord -> WET54G should work OK now.
    In my case it helped. I ve spent more than two days looking for solution and searching web for info - without luck. So I post my solution here.
    Merry Christmas and Happy New Year
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice