1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

LINKSYS WRT54GS CLIENT MODE??? PLZ HELP

Discussion in 'Sveasoft Firmware' started by 2fast, Dec 31, 2004.

  1. 2fast

    2fast Guest

    I know there have been a lot of posts about his problem but I really need some help and I need it fast.

    So, I've downloaded Sveasoft's satori4.0 firmware for my Linksys wrt54gs and I've upgraded my ap. I found the client mode, and wanted to connect to a certain ap, but my problems started here.

    I mounted my parabolic Pacific Wireless 19dB antenna on the roof. connected it with my laptop, did the site survey and I found my friends SSID (the signal was measured with Net Stumbler and it was good), and then I connected my antenna on the ap. How do I configure the ap to make it connect to the ap that i want???? My friend told me that
    I need to find some kind of a message box to enter some commands to connect to a certain ap. His answer was that my ap with this firmware cannot connect automaticly so i need to enter some commands manually?

    Is that correct? Can somebody please help me with this?
    Any experience???

    TNX
     
  2. Toxic

    Toxic Administrator Staff Member

    mac address filtering? set encriptionand pwd so only the twp APs have the same pwd?

    also try here:

    http://docs.sveasoft.com/
     

Share This Page