Logging WAN-IP

Discussion in 'Tomato Firmware' started by willi007, Nov 26, 2007.

  1. willi007

    willi007 LI Guru Member

    Hi, with the tomato 1.11.1217 the logfile do not register the new wan-ip after a reconnect. Please, what shell I do?
    And: What are the different between the "loglevels"?
    Thanks a lot
    Willi007
     
  2. mstombs

    mstombs Network Guru Member

    You just need to paste something like this in the WANUP or firewall script:-
    Code:
    logger "WANUP: New IP address is $(nvram get wan_ipaddr)"
     
  3. willi007

    willi007 LI Guru Member

    Many thanks!
     
  4. mstombs

    mstombs Network Guru Member

    Your welcome!

    I also had a look at the 'Console log level' in 'Administration - debugging' It seems this is a number 1-8 in the gui and busybox code but I can't find the exact definition - there's a dozen copies of syslog.h in the source code tools one of which suggests

    Code:
     *
     * priorities (these are ordered)
     */
    #define	LOG_EMERG	0	/* system is unusable */
    #define	LOG_ALERT	1	/* action must be taken immediately */
    #define	LOG_CRIT	2	/* critical conditions */
    #define	LOG_ERR		3	/* error conditions */
    #define	LOG_WARNING	4	/* warning conditions */
    #define	LOG_NOTICE	5	/* normal but significant condition */
    #define	LOG_INFO	6	/* informational */
    #define	LOG_DEBUG	7	/* debug-level messages */
    error by 1 is one of the most common errors...
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice