1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

MAC addresses of wired devices connect to "slave" routers?

Discussion in 'Tomato Firmware' started by mvsgeek, Dec 29, 2011.

  1. mvsgeek

    mvsgeek Addicted to LI Member

    Is it possible in Toastman builds to get a list of all wired devices connected to "slave" WDS+AP routers? They show up in the main router's device list, but the slaves' device lists only show wireless connections. I was hoping to find a file or nvram variable which contains this info, so far without success. I'm trying identify which of the slaves has a particular bandwidth hog connected to it.
     
  2. jsmiddleton4

    jsmiddleton4 Network Guru Member

    Only way I've found is to add them to the static dhcp list in the slave. Do not turn on anything. Just add them. They'll show up in device list.
     
  3. mvsgeek

    mvsgeek Addicted to LI Member

    Sorry, I should have mentioned that there are 9 slaves - I'm trying to find the one to which the hog is connected via cat5.
     
  4. jsmiddleton4

    jsmiddleton4 Network Guru Member

    The utilization graphs in the master should be accurate for slave attached devices.
     

Share This Page