Modify MAC Filter via SNMP

Discussion in 'Other Linksys Equipment' started by simplify, Jun 2, 2005.

  1. simplify

    simplify Guest

    I have attempted to add/remove MAC Addresses from the MAC Filter Section of my WAP56G Access Point VIA SNMP with no luck. When I make a change, with no reported errors, to the MAC Filter Table, the web interface does not recognize the change, and if the access point is rebooted, the MAC Filter table is reloaded to the last changes made via the web interface. (I am unsure if the changes via SNMP actully take effect, I have not tested that)
    I have made changes to other sections of the access point, with success. The only area I am having difficulty with is the MAC Filter Section.

    NOTE: when a change it made via SNMP, a SNMP read will read the new value, but the web interfave does not.

    I am running firmware 2.07

    Please help.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice