More Development Stuff

Discussion in 'General Discussion' started by t4thfavor, Aug 1, 2006.

  1. t4thfavor

    t4thfavor Network Guru Member

    I have successfully built the *.bin files for the dd-wrt firmware, but now i just want to compile my own software written in C, or C++. I can not for the life of me figure out what commands to run on my source files to get them to output in the MIPS binary format. I can get my stuff to compile for x86 using gcc hello.cpp
    Im sure there is a way to say something like gcc -b <processor> hello.cpp
    and make it output in the MIPS binary format. Any help would be great.


    I have the toolchain installed that is on the dd-wrt site and it is running on a debian hard disk install (M$ Virtual PC).

    TIA
    --
    Chance
     
  2. t4thfavor

    t4thfavor Network Guru Member

    dun figured it out by trial and error.
    I have to use the Mipsel compiler... DUH.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice