Moving from 54G ver2 to 54GS ver2 -> backup configuration

Discussion in 'Tomato Firmware' started by luke-san, Jan 27, 2007.

  1. luke-san

    luke-san LI Guru Member

    Hi people,


    I just obtained a WRT54GS ver2 to add to my already 2 other WRT54G ver2 devices.

    My current setup is that I use a WAG54GX2 as a ADSL modem that is set to bridge mode for the time being (ISP will place Fritz router with voip)
    So 1 is wan-connected to the 'adsl-modem' and acts as a ppoe handler, dhcp, and router.
    The other one is 2 floors up and acts as a simple AP for the upper part of the house and the garden.

    Now since the GS has more memory and has a faster cpu I want to use this to replace the 1st one.
    The problem is that I have setup alot of QoS rules and other stuff which I really need.
    I am too lazy to take screenshots and redo the job on the GS. :biggrin:
    You can backup the configuration in the Tomato software, BUT... will it work on the GS ?
     
  2. der_Kief

    der_Kief Super Moderator Staff Member Member

    Hi,

    the proof of the pudding is in the eating :biggrin:
    Seriously, try it i think you cannot damage anything (no guarantee)

    der_Kief
     
  3. luke-san

    luke-san LI Guru Member

    Lets say that the pudding didn't taste that good

    Invalid hardware type: 00000001 / 00000002
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice