Multi access point wireless network for VOIP

Discussion in 'DD-WRT Firmware' started by mtp337, Jan 6, 2006.

  1. mtp337

    mtp337 Network Guru Member

    Aloha all,

    I have been searching the forum for info in an effort to install a multi access point wireless network for VOIP. I have gotten a ton of useful information and want to say mahalo! (hawaiian thanks)

    I would love any additional comments about my design you all might have.

    Design:
    I will be using 5 wrt54g's (hardware ver 4) running dd-wrt v23 std. They will all be connected via cat5 so no wds/bridging necessary. There will be 3 wired phones (polycom 501's and 4 wireless ZyXel P-2000w's)

    I have a considerable amount of experience using cisco's aironet products and antenna's indoor and outdoor and have done a basic wireless site survey.

    my house has all metal walls outside and a few wood and sheet rock inside. The exterior walls will really suck, since they will block the signals and no doubt cause a lot of multi path interfearence. To accomidate this and extend the range of the wireless signal I am using wall mounted patch antennas (with RX/TX diversity in mind).

    There are 3 floors and they span a large area, so the AP's will be set to 3 non overlapping channels (1,6,11) in order to cover the whole area.

    Has anyone tried something like this yet?

    aloha
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice