1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Multiple WAN ip's

Discussion in 'Tomato Firmware' started by visiperl, Jun 8, 2007.

  1. visiperl

    visiperl LI Guru Member

    Hi all,

    I've read... and read... and read... and am still having problems getting multiple wan ips working with the tomato firmware.

    I found this thread;
    http://www.linksysinfo.org/forums/showthread.php?t=51451&highlight=multiple+wan

    And while it does create the ip and I can ping that external ip from the LAN side, I still am unable to touch any services from the WAN side.

    Does anybody have any good suggestions that might help with this?

    Thanks,
    Ken
     
  2. commandonut

    commandonut LI Guru Member

    Me too, i have problem about WAN too,

    last 2 day. I'm looking in realtime monitor in tomato,

    realtime monitor show me [ WAN0 , WAN1 , WAN2 ] usually WAN0 only.

    after that i try to change setting, but i can't. when i change something in

    any setting. The connect was disconnected. and i can not connect to the

    internet again .


    sorry about my English language,

    command's

    thanks you,
     
  3. visiperl

    visiperl LI Guru Member

    Mine is now working. The isp had to make a correction on their end regarding my ip address. Once that was done, everything started working.

    Cheers!
    ken
     

Share This Page