Nas200 and problem with hdparm

Discussion in 'Cisco/Linksys Network Storage Devices' started by 4d45ch, Dec 7, 2008.

  1. 4d45ch

    4d45ch Addicted to LI Member


    my two disk in nas200 don't stop automticly (setting under web config)

    this too don't work after using hdparm -sleep mode (jac0 firmware)

    any ideas?

    2xseagate 1TB in raid 0

  2. fubarbloke

    fubarbloke Addicted to LI Member

    A couple of thoughts:

    1. Have you de-selected the UPnP option under System Options in the Admin web interface? After I did that, my NAS200 went to sleep per the settings under Disk Utility.

    2. The Jac0 mod does not claim to support a RAID config. I know people have set it up that way, but from what I've seen on this board it's been with mixed results.

    Good luck!
  3. pabpoo

    pabpoo Addicted to LI Member

    My nas200 always goes to sleep at 30 min, no matter if I select 10 o 30 minutes after idle.

    another way to change the sleep time?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice