1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

NAS200 can't see new disk in bay1

Discussion in 'Cisco/Linksys Network Storage Devices' started by marcars, May 1, 2012.

  1. marcars Reformed Router

    Hi,
    i have a problem with my nas200. After replace a harddrive from 160GB to 250GB they don't recognize it. The disk led on nas200 have not a led light. But the disk ist recognized in bay 2. Wher is the problem?
    marcars, May 1, 2012
    #1

  2. jac_goudsmit Super Moderator

    It could just be a bad or dirty contact on the bay 1 connector inside the NAS. If your disk works in bay 2 and you have no other disk, you can always run it in bay 2.

    ===Jac
    jac_goudsmit, May 1, 2012
    #2

  3. marcars Reformed Router

    thanks for replay. The problem is when i switch disk from bay2 to bay1 then nas200 donst see it in bay1. I have a two disk : bay1- 140GB bay2 - 400GB. When i switch the disk in bay1 with new disk 250GB then the nas200 start very long and after that he don not see new disk. I have tried this switching yesterday all day:). Is ir possible that may nas dont see in bay1 250GB disk sata2?
    marcars, May 2, 2012
    #3

Share This Page