NAS200 RAID 1 [How to replace one of the Drives]

Discussion in 'Cisco/Linksys Network Storage Devices' started by rmcinnes, Oct 8, 2008.

?

Based on your experience, can you confirm this procedure.

Poll closed Nov 7, 2008.
  1. Confirmed, I have tried and proven the procedure...

    0 vote(s)
    0.0%
  2. Have not tried, but procedure is documented [include reference]

    0 vote(s)
    0.0%
  3. No experience, I am unable to help

    100.0%
  1. rmcinnes

    rmcinnes Addicted to LI Member

    How do I replace one of the 500GB hard drives in my NAS200 RAID 1 Configuration.
    It is my intention to remove one drive, which will then become my Off-Site storage/backup.
    And replace it with a new 500GB Drive.

    I feel I need step by step guidance with this task...
    To help me avoid impacting the integrity of data on the Top Drive during the swap over of the Bottom Drive.

    I would appreciate comment from someone who has successfully tackled this...

    From what I have read in this Forum, I believe all I need to do is...
    a) turn off the NAS200 power,
    b) remove the lower drive,
    c) insert the new drive,
    d) turn on the power and a few hours later, the new disk mirroring will be complete.

    Confirmation please...

    Thanks...
    Robert
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice