Need Dual-WAN Script for Tomato 1.21

Discussion in 'Tomato Firmware' started by bym007, Oct 30, 2008.

  1. bym007

    bym007 Addicted to LI Member

    Need Dual-WAN Load Balancing Script for Tomato 1.21

    Hi fella's,

    Firmware Version: Tomato 1.21
    Device: Buffalo WHR-G54-S


    Currently my cable modem A is connected to the WAN port of the buffalo and working fine.
    I have activated second connection to same ISP and now have another cable modem B sitting idle.

    I would like to use a Dual-WAN configuration on my Buffalo now.

    I have seen some forums talk of using another LAN port as second WAN and then load-balancing them, but am unable to find a working config/script anywhere.

    I am prefer to use some decent load balancing rather than just plain round-robin.

    Any ideas ?

    Many thanks ...
     
  2. wdca

    wdca LI Guru Member

    Read Linux Advanced Routing And Traffic Control
     
  3. mstombs

    mstombs Network Guru Member

    I got as far as having 2 WAN connections and switching between them - but never got both working together prperly, not try any load balancing. See dd-wrt for working examples of 2 or 3 WAN ports - but watch out I recall it doesn't work with the very latest versions.

    http://www.dd-wrt.com/phpBB2/viewtopic.php?t=13869
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice