Need help setting up wireless bridge

Discussion in 'General Discussion' started by jeigh, Jun 3, 2011.

  1. jeigh

    jeigh Networkin' Nut Member

    I'm a newb here, and this is the first time setting this up. a friend of mine introduced me to bridging and I figured I'd give it a go. i set everything up fine at his place then tried to transfer it to my home network it just didn't take all that well.

    What i have is two linksys routers. One is stock out of the box, freshly reset with no additional changes. This is the primary one connected to the cable modem. It is a wireless N router. The second is a wireless G flashed with tomato firmware to allow it to act as a bridge.

    What i cannot gleen from any other forum is how to make these two communicate. Any help would be appreciated. Thank you
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice