Need Help setting WVC54g Wireless

Discussion in 'Other Linksys Equipment' started by DelToro, Aug 7, 2005.

  1. DelToro

    DelToro Guest

    I´m desperate,
    I can´t make my camera works in wireless mode. Works fine wired. I have a WAG54G. I have disabled security in both of them, open 1024 TCP port in single port forwarding, I have set up a fixed IP in the camera. WAG54G is with DHCP enabled. Im totally confused, please any tips, help will be appreciated
  2. cdiaz

    cdiaz Network Guru Member

    You should set a static ip adress to the Linksys Camera (only to reduce possible problems)

    Configure the WAG54G security mode, WEP 128 Shared Key should be right.
    - Set a SSID (the same word on WAC54G and WVC54G)
    - Set the AP Mode to Access Point
    - Channel 6

    On the Camera, the same security setting (WEP and Shared Key). SSID, and Channel (6).
    - Network Type Infrastructure

    Good Luck
  3. DKNY2000

    DKNY2000 Network Guru Member

    thank you guy's
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice