Need help to setup as a bridge

Discussion in 'Tomato Firmware' started by clb239, Sep 18, 2011.

  1. clb239

    clb239 Networkin' Nut Member

    I have installed tomato on a Linksys WRT54G v1.1

    I would like to use it as a bridge to create a wired network in a separate part of my apartment from where the wireless router and cable modem is located...

    Can anyone provide any guidance on how to set this up...

    Thanks in advance
     
  2. Hogwild

    Hogwild Addicted to LI Member

    clb239:

    There are already quite a few tutorials on the web out there on this subject. Many of them take you through
    every single step. Check Youtube using "tomato bridge setup" or even Google. That would give you a start,
    and as you went through the steps, maybe you could post your problems/questions here.

    Oh, and you'd want to post more information about your equipment and configuration as well.

    Hogwild
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice