Need help with 802.1q tagging

Discussion in 'Tomato Firmware' started by kthaddock, Feb 23, 2012.

  1. kthaddock

    kthaddock Network Guru Member

    I'm trying to do this setup but no luck so far. I trying to tagg port 3 with all my bridges and wan. Is there any trick that I not aware of,one extra blank VID-raw? I'm going to feed my GS-105E switch with one lan-cable and connect device on br0, br1 and wan. I have VID 1-3

    EDIT: The trick was: have to tagg eg port3 first and then all others.
    Then I get br0, br1 and wan tagged to port 3. Duh I'm feeling like HOMER :oops:

    kthaddock
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice