Need PPPoE commands for a script.

Discussion in 'Tomato Firmware' started by MrEvil, Nov 25, 2010.

  1. MrEvil

    MrEvil Network Guru Member

    Quick Question:

    I'm working on a script on my WRT54G v4 running Tomato 1.27 and I'm needing to script PPPoE on an interface. What are the Commands for establishing a PPPoE connection from the command line?
     
  2. bogderpirat

    bogderpirat Network Guru Member

    Code:
    usage: pppoecd interface -d -k [-i idle] [-u username] [-p passwd] [-a acname] [-s srvname] [-r mru] [-t mtu] [-I lcp_echo_interval] [-T lcp_echo_fails] [-P ipparam] [-L Local IP] [-N retry_num] [-R set default route] [-6 enable PPP IPv6CP] [-n use unnumber ip] [-C disconnected function] 
    mine says:
    Code:
    pppoecd vlan7 -u XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX -p XXXXXXXX -r 1492 -t 1492 -i 0 -I 30 -N 5 -T
     
  3. MrEvil

    MrEvil Network Guru Member

    Thanks a ton man. Helps me tremendously.
     
  4. MrEvil

    MrEvil Network Guru Member

    One more question, does pppoecd configure the IP address and such? Or do I need a separate string for that as well.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice