Need Telnet Command to verify over-clock

Discussion in 'Tomato Firmware' started by LanceMoreland, Jul 11, 2010.

  1. LanceMoreland

    LanceMoreland Network Guru Member

    I just went from Tomato 1.25 RAF to Tomato 1.28 and since there is not web interface to over-clock I manually sent the over-clock commands to my routers via telnet. I can't find the command that would report the clock speed to verify that the command took. Anyone know what that might be?
     
  2. LanceMoreland

    LanceMoreland Network Guru Member

    I found it. If others need to know it is:

    nvram get clkfreq
     
  3. mstombs

    mstombs Network Guru Member

    But you also should check how effective the command was as increasing the BogoMIPS observed effective CPU rate - clearly I have lost my 250MHz overclock here :-

    Code:
    Tomato v1.27.9047 MIPSR1-beta15 K26 USB Ext
    
    
    BusyBox v1.16.1 (2010-06-03 16:13:56 EDT) built-in shell (ash)
    Enter 'help' for a list of built-in commands.
    
    root@wrt54g-tm:/tmp/home/root# cat /proc/cpuinfo
    system type             : Broadcom BCM5352 chip rev 0 pkg 2
    processor               : 0
    cpu model               : Broadcom BCM3302 V0.8
    BogoMIPS                : 199.47
     
  4. LanceMoreland

    LanceMoreland Network Guru Member

    Thanks. The command that you provided is really what I was looking for. The command that I provided will only tell you what is saved to the navram. cat /proc/cpuinfo shows you what is really happening. Looks like I am good to go.
     

    Attached Files:

  5. LanceMoreland

    LanceMoreland Network Guru Member

    Is there a similar command that would verify an increase in transmit power?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice