Network config+quickVPN

Discussion in 'Networking Issues' started by sabinog, Aug 10, 2006.

  1. sabinog

    sabinog Network Guru Member

    Hello all,
    I'm having some problem with the config of my network.......I have 1 ag241 (gateway 1° net), 1 rv042 (router 2° net) and 1 wrt54g (3° net).
    the problem is that I can't connect to rv042 with quickVPN......
    infact after 2-3 min of trying the quickvpn tell me that rv con answer........when I look log on rv there's nothing about port 443 or 60443.....only a block on a upnp roules????......can anyone help me?? tnx
     
  2. Toxic

    Toxic Administrator Staff Member

    I take it your trying to connect from the internet to your rv042 that is behind the AG241? yes?

    then you will need to port forward TCP 443 and/or TCP 60443, and IPSec UDP 500 from the AG241 to the WAN address of your RV042.
     
  3. sabinog

    sabinog Network Guru Member

    tnx toxic,
    I read your replay only now.......
    I alredy try to open the 443 60443 on rv but UDP cause by a port analizer I look UDP and not TCP.......however I've forward also the 443, 60443 on ag241.....nothing appen..........when I look the VPN interface I look that the user is been connected from almost 6 min.......but the quickvpn break the connection after network convalidation and the sw tell " router is not responding"!!!!!
    I see by netstat -na that the connection is open for only some second......???

    I' m been connected by QuickVPN only one time.........when I had dlink 300 (eth/modem)......I change it because I need QoS for VOIP......

    another change I've done is the sub that finish with 248.....

    Have you other tips...........tnx 4 your hlp!
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice