1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Networking Help - Thibor Wet

Discussion in 'Networking Issues' started by zmahomedy, Oct 31, 2007.

  1. zmahomedy

    zmahomedy LI Guru Member

    HI

    I am having trouble with one of my nodes using WET MODE using the THBIBOR firmware.

    At the moment this is my network topology.

    I have a gateway which links up 2 routers
    One of the routers in turn setup 2 seperate WET links
    And the other router setup 1 WET link

    The second router which has 1 WET link is not stable. If there is a powerloss etc, the link doesnt come back on. Evertime I need to go into the settings an play around with spanning tree protocall and or RIP. After trial and error the link comes back on. The rest of the network is stable.
    Signal strength is fine on all sides.

    Spanning tree protocall and RIP is not enable in any of the routers except the one the problematic one.

    I attached a picture of the network topology

    Note this is a small network for my friends and family who live close by.


    Config settings for the routers

    Gateway.. gateway mode
    AP mode
    Channel 1
    no security
    SSID: mynetwork1
    IP: 192.168.5.1
    spanning tree off
    RIP off

    Router 1.. router mode
    AP mode
    Channel 1
    security enabled WPA
    SSID: mynetwork1
    LOCAL GATEWAY: 192.168.5.1
    LCOAL DNS: 192.168.5.1
    spanning tree off
    RIP off

    Router 2-- router mode
    AP mode
    Channel 6
    security enable WAP
    SSID: mynetwork2
    LOCAL GATEWAY: 192.168.5.1
    LCOAL DNS: 192.168.5.1
    spanning tree off
    RIP off

    ============================================
    WET CLIENTS FOR ROUTER 1

    WET mode
    Channel 1
    security enabled WPA
    SSID: mynetwork1
    LOCAL GATEWAY: 192.168.5.1
    LCOAL DNS: 192.168.5.1
    spanning tree off
    RIP off

    ============================================

    WET CLIENTS FOR ROUTER 2
    WET mode
    Channel 6
    security enabled WPA
    SSID: mynetwork2
    LOCAL GATEWAY: 192.168.5.1
    LCOAL DNS: 192.168.5.1
    spanning tree on /off
    RIP off/on

    spanning tree /rip on or of.. trail and error to get connection
    if power goes off connection doesnt estiablish itself again


    any insist or help appriciated

    In the attached picture, router C with router H is the problematic link

    thanks

    zakir
     

    Attached Files:

Share This Page