1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

New How-to for WDS's for Talisman 1.2? and overclocking?

Discussion in 'Sveasoft Firmware' started by Drillbit97, Oct 16, 2006.

  1. Drillbit97

    Drillbit97 LI Guru Member

    Is there one? I'm currently searching the forums and can ont find any in english. I see the one stickied in the Deutsch but I cant read it. I'm trying to redo my network 5 linksys WRT54G v1-3's all flashed with 1.2. Thanks

    I working with this

    WRT54G Router #1:

    Automatic Configuration-DHCP

    Network Setup:

    Local IP Address: 192.168.1.1
    Subnet Mask: 255.255.255.0
    Gateway: 0.0.0.0

    DHCP Server: Enable

    Wireless Setup:
    Wireless Mode: AP
    Wireless Channel: (Same Channel as WRT54G #2)

    Wireless WDS:

    LAN : (Wireless Mac Address of WRT54G #2)
    Lazy WDS: Disable
    WDS Subnet: Disable


    WRT54G Router #2:

    Automatic Configuration-DHCP

    Network Setup:

    Local IP Address: 192.168.1.2
    Subnet Mask: 255.255.255.0
    Gateway: 0.0.0.0

    DHCP Server: Disable

    Wireless Setup:
    Wireless Mode: AP
    Wireless Channel: (Same Channel as WRT54G #1)

    Wireless WDS:

    LAN : (Wireless Mac Address of WRT54G #1)
    Lazy WDS: Disable
    WDS Subnet: Disable

    my question now is what are the setting for if used, or please add if I did not list: Setup/Advanced Routing, Wireless/Advanced Settings, Wireless/WDS, Security/Firewall, Administraion/Management

    My other question is I move large 3+GB files around on my network, and it ways drops the file, what are the setting to help that, or is it the overclocking issue?

    And lastly, is it possible to have it set so when my friends come over or guests, that they can just log onto my network without assinging an ip address / with password I'm using WEP. The password is not an issue, its just the hassle of setting up the ip's.

    Thank you.

    ok I have

    talisman 1.2 Main Router working
    talisman 1.2 Living room not working with main
    talisman 1.0.5 Basement working with Main
    talisman 1.0.5 Attic working with Main
    talisman 1.0.5 Outside working with main

    I have main DHCP Server: Enable 10-60
    living room DHCP Server: Enable 61-110
    basement DHCP Server: Enable 111-160
    attic DHCP Server: Enable 161-210
    outside DHCP Server: Enable 211-250

    I have all firewalls off.

    Could someon toss me clue please
     

Share This Page