1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Newbie help request - set-up & network time problems

Discussion in 'Tomato Firmware' started by bunk3m, Aug 18, 2011.

  1. bunk3m

    bunk3m Networkin' Nut Member

    Hi all. I've just started using Tomato last week (v1.28.1816).

    I can't get the time to show-up. I figure it is how I set up the WRT54GL1.1. I've read the FAQ at Polarcloud, Install Guide (wiki), and read a bunch of FAQ in this forum. But I haven't figured out the problem yet. I'm a newbie to this and apologize if this is a stupid question.

    My network:
    DSL modem connected to a Linux server (192.168.1.1).
    I have two network segments. 192.168.1.x is wired ethernet. The other uses the Tomato to provide wifi access only. Tomato has static IP 192.168.2.2. I've tried gateway and router mode and neither works to get Tomato to use ntp or have the correct time. I can connect to the server, and internet through wifi. So I'm not sure why the time isn't being set.

    More details are included in the attached diagram.
    Network Diagram.png
    I suspect I have to do something with the routing but have no idea where to start. This is what I have in the routing table.
    Could you give me some guidance? Thanks in advance.
     
  2. ntest7

    ntest7 Network Guru Member

    I assume your linux box has two IP addresses 192.168.1.1 and 192.168.2.1, since that's the only way your diagram makes even a little bit of sense.

    On the tomato, the WAN type is "disabled", and the gateway will be 192.168.2.1. Don't plug anything into the WAN/Internet port on the linksys; use the regular LAN ports for the wired uplink.
     
  3. bunk3m

    bunk3m Networkin' Nut Member

    Yes. The server has both IP addresses. 192.168.1.1 & 192.168.2.1. And WAN is disabled.
    Sorry for not putting it there.

    I changed the gateway to 192.168.2.1 and it works!

    Thanks so much!
     

Share This Page