Newbie Question: default address for Linksys w/Tomato as BRIDGE

Discussion in 'Tomato Firmware' started by Girardian, Dec 17, 2007.

  1. Girardian

    Girardian Guest

    I went through the admin setup of my Linksys GL router w/ Tomato and when I changed the router to a "wireless bridge" I did not manually set up the IP address. Now I don't know what the default is. The router does not appear @ 192.168.1.1. any longer.

    Any suggestions?
     
  2. TheGIZ

    TheGIZ Network Guru Member

    Press reset on Tomato router. GO back in there and set it up with a Static IP that is out side of the DHCP pool. And then change it to a bridge. Should only take a few minutes.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice