1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Newbie with first time setup problems

Discussion in 'Cisco/Linksys Wireless Routers' started by AK75, Dec 2, 2005.

  1. AK75

    AK75 Network Guru Member

    I’m a networking newbie so please be easy on me. I am attempting to setup my first wireless network. My goal is to be able to stream MPEG2 video from my computer to the TV with the Hauppauge Media MVP. I have a WRT54G V3 and WRT54GS V3 both flashed with DDWRT v23 firmware. My setup is the following:

    Computer->wired->WRT54GS (wireless w/ WDS) WRT54G in bridge mode->wired->Media MVP to TV

    I used the following link to change the router settings:


    After I changed the settings on the router and the bridge they now intermittently will not connect the computer when hard wired to the computer network card. The router power light is on solid and appears to be working correctly. After this happened the first time I reset to original condition and reflashed with no problem. Now again sometimes will not connect to network card when hard wired.

    I’m not sure what the problem is. Do I need to reset router after changing settings? If so, what is correct procedure? Firmware problem? Network card setting? Any input would be greatly appreciated

Share This Page