1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

no bandwidth stats in tomato?

Discussion in 'Tomato Firmware' started by Chris1983, Oct 28, 2010.

  1. Chris1983

    Chris1983 Networkin' Nut Member

    Im using a RT-N16 in AP mode with its on static IP with tomato Firmware v1.28.9052 MIPSR2-beta23 K26 USB Ext

    I'm not getting any bandwidth totals in daily etc, i can see my traffic in real time though.

    I tired check where it says use WAN port for lan and it made no differance. DHCP is disabled since there already is a router with DHCP on my network which is at a different location.

    I am simply using the N16 for wireless and hardwired at a different location and need to keep an eye own bandwidth stats.

    BTW bandwidth stats is on :)
     
  2. rhester72

    rhester72 Network Guru Member

    Did you set up a place to store the bandwith stats? It won't display anything other than real-time without it being stored somewhere, and make sure you check "create new file" during setup.

    Rodney
     
  3. Chris1983

    Chris1983 Networkin' Nut Member

    It was set to the defaults which is store in the RAM and i did check the create new file during setup........does it take awhile for the stats to show maybe?
     
  4. Chris1983

    Chris1983 Networkin' Nut Member

    what is the url of a usb thumb drive connected to the router? Also what does the usb drive need to be formated to?
     
  5. Chris1983

    Chris1983 Networkin' Nut Member

    Would i not be getting any stats since im not using DHCP?
     
  6. rhester72

    rhester72 Network Guru Member

    Good question...it's possible. Do you have a WAN IP defined?

    Rodney
     
  7. Chris1983

    Chris1983 Networkin' Nut Member

    No just LAN IP. Others have said that i will not get any bandwidth stats since im using it as a AP and no data is going over the WAN port.

    Is that true?
     
  8. rhester72

    rhester72 Network Guru Member

    It is true - the bandwidth stats are enabled only if outbound traffic goes over the WAN port.

    Rodney
     

Share This Page