No graph on Real-Time Bandwith and Last 24 Hours?

Discussion in 'Tomato Firmware' started by micko_escalade, May 31, 2009.

  1. micko_escalade

    micko_escalade Network Guru Member


    Just came back from friend where I installed tomato v1.25 on his WRT54G v2 router.
    Small issue that I noticed was that no graph was displayed on Real-Time Bandwidth and Last 24 Hours.
    Transfer was counted but no graph.
    I check and he had Java installed on his computer, what else could cause this?
  2. martinqiu

    martinqiu Addicted to LI Member

    You need SVGView
  3. Toastman

    Toastman Super Moderator Staff Member Member

    Pie charts too? Then he probably used IE which did not have SVG graphics installed. Most other browsers support SVG natively.

    Can be downloaded and instals easily - you can ring him up and tell him.
  4. micko_escalade

    micko_escalade Network Guru Member

    Yep, that's what it was. He is using IE7. All o.k. now!
    Thanks Guys!
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice