Noise is always -100dBm

Discussion in 'DD-WRT Firmware' started by atpanula, Jan 7, 2006.

  1. atpanula

    atpanula Network Guru Member

    Hello!

    I have always a client noise level of -100dBm in status - wireless clients with WRT54GSv4 + DD-WRT v23 final. Remote wireless bridge is WET54G with latest official Linksys firmware that is 2.10. Both locations have homebrew cantennas about 1000 feet apart. Almost a line-of-sight, only some trees in the way.

    My router shows signal levels around -75 which gives a connection of 24 or sometimes 36Mbps. Comments? It would be nice to monitor noise too because signal level itself is useless information when noise is high.

    Now the question: Can the remote wireless bridge WET54G send the noise information to the router - or is the noise measured at the router location? If so, why is it not working?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice