Not a brick, but can't contact after upgrade to Alchemy 1.0

Discussion in 'Sveasoft Firmware' started by erikbledsoe, Apr 29, 2005.

  1. erikbledsoe

    erikbledsoe Guest

    Last night I upgraded to Alchemy 1.0. I can still access the internet, but I can't connect with my router. Trying to access it through the browser gives me a connection time out or connection refused.

    Trying to ping it from the command line gives me either a "destination net unreachable" or a simple "request timed out" error.

    I also tried to load a different firmware using tftp but it couldn't connect either.

    Any ideas?
  2. sdy_moscow

    sdy_moscow Network Guru Member

    Look here...
    If it seems to be that probem then wait some time and start pinging you router continues (with -t). Tray continues rebooting it by pluging and unpuging power. At same time it is start to response you ping (DMZ will lighting) after that if it will be posible try to enter into its web interface, if it is not posible - use TFTP. Put in you router standart firmware or HyperWrt ffirmware. Ofcouse you can try after that upgraid it again to Alchemy. But seems it will be not work.
  3. chanchiya

    chanchiya Network Guru Member

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice