1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

NSLU2- cant telnet conect

Discussion in 'Cisco/Linksys Network Storage Devices' started by offlink, Aug 30, 2007.

  1. offlink

    offlink LI Guru Member

    i have unslung 6.8 and...

    i've switched on ENABLE TELNET in www, and using putty log in into my hardware. login, password and nothing...exit or once i have that message

    NUSL2 login: admin
    Password:
    No directory, logging in with HOME=/

    Welcome to Unslung V2.3R63-uNSLUng-6.8-beta

    -------- NOTE: RUNNING FROM INTERNAL FLASH --------

    This system is currently running from the internal flash memory,
    it has NOT booted up into "unslung" mode from an external drive.

    In this mode, very few services are running, and available disk
    space is extremely limited. This mode is normally only used
    for initial installation, and system maintenance and recovery.
    Cannot execute /dev/null: Permission denied

    uNSLUng status: Running from Internal Flash

    i've read on forum i must unsling my flash into other memory but how? i can't telnet into my hardware?
    login : root Password: uNSLUng on my nslu not working...
    please help me...
    sorry for my english :/
     
  2. mstombs

    mstombs Network Guru Member

    Its a while since I did this but I recall the username is different between web interface and telnet - see this step of the readme

    so try the username: root and password: uNSLUng
     
  3. offlink

    offlink LI Guru Member

    don't work. only admin/admin i can connect. after login i have that

    NUSL2 login: admin
    Password:
    No directory, logging in with HOME=/

    Welcome to Unslung V2.3R63-uNSLUng-6.8-beta

    -------- NOTE: RUNNING FROM INTERNAL FLASH --------

    This system is currently running from the internal flash memory,
    it has NOT booted up into "unslung" mode from an external drive.

    In this mode, very few services are running, and available disk
    space is extremely limited. This mode is normally only used
    for initial installation, and system maintenance and recovery.
    Cannot execute /dev/null: Permission denied

    uNSLUng status: Running from Internal Flash

    and exit program. i try change username user root but this didnt work.
     
  4. mstombs

    mstombs Network Guru Member

    Do you have any disks attached - the instructions say don't at this stage?
     
  5. offlink

    offlink LI Guru Member

    ok after upgrading firmware i finally unsling my flash into pendrive, but after taht i again cant login into telnet!

    i have that message

    LKG351FD6 login: admin
    Password:
    No directory, logging in with HOME=/

    Welcome to Unslung V2.3R63-uNSLUng-6.8-beta

    ---------- NOTE: THIS SYSTEM IS CURRENTLY UNSLUNG ----------
    Cannot execute /dev/null: Permission denied

    wht goes wrong?
     
  6. offlink

    offlink LI Guru Member

    i really dont understand my nslu... after unsling flash into my disk2, still i cant telnet into nslu, root, uNSLUng didnt work after unsling, and admin/admin work but i have that comunicate...

    LKG351FD6 login: admin
    Password:
    No directory, logging in with HOME=/

    Welcome to Unslung V2.3R63-uNSLUng-6.8-beta

    ---------- NOTE: THIS SYSTEM IS CURRENTLY UNSLUNG ----------
    Cannot execute /dev/null: Permission denied
     

Share This Page