NTL cable modem adapter problems, linksys wrt54g

Discussion in 'Cisco/Linksys Wireless Routers' started by alfranko, Aug 30, 2005.

  1. alfranko

    alfranko Network Guru Member

    Hi there guys, newbie

    Have managed to get ntl to install but not through the installer but with technical support. Strange i know (the installer always gives errors).

    I now try to install the linksys wrt54g router. Like it says, have an active internet connection to use cd, so i have. Setup comes with the error "there is no internet connection".

    I have read through the manual and it says i need to make the adapter to Obtain Ip Address.

    Adapter 7 - Ethernet adapter
    Use the following IP address
    Ip Address - 192.168.0.1
    Subnet mask - 255.255.255.0

    Adapter 6 - USB
    Obtain IP automatically
    In IPConfig the details :
    IP Address. . . . . . . . . . . . : 82.9.58.33
    Subnet Mask . . . . . . . . . . . : 255.255.255.0
    Default Gateway . . . . . . . . . : 82.9.58.254

    The strange thing also, even the internet via USB, if i change the ethernet adapter config, internet fails.

    Information which might help cause
    =========================

    Cable modem MAC 00:0E:9B:F1:91:52
    Internet Via USB cable to modem
    Windows Xp Pro
    Router wrt54g


    Sorry about the length, but any help greatly appreciated
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice