Nvram variable question (Speedbooster)

Discussion in 'HyperWRT Firmware' started by jruschme, Feb 26, 2006.

  1. jruschme

    jruschme Network Guru Member

    I have a WRT54G v2.2 running Tofu 13d.

    I was looking through the nvram variables and noticed the following two:

    wl0_afterburner
    wl_afterburner

    both of which are set to false.

    Will setting those to 'true' make any difference or will I have to load Thibor to enable Speedbooster? (Yes, I have clkfreq set to 216.)

    Also, what is the difference between the wl0_ and wl_ variables?

    Thanks...
    John
     
  2. Thibor

    Thibor Super Moderator Staff Member Member

    afterburner is set by default to auto, so if there are any speedbooster enabled clients; it will automatically activate. otherwise you can set 1 to force it on, -1 is auto
    the wl_ and wl0_ don't matter, the wl_ variables get copied to wl0_ at boot time
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice