1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Odd intermittent problem with Tomato/WHR-HP-G54

Discussion in 'Tomato Firmware' started by JPorter, Jun 5, 2008.

  1. JPorter

    JPorter LI Guru Member

    I'm having an odd issue where occasionally the router will stop passing LAN traffic across between the wired and wireless sides of the box, but will continue to pass WAN (internet) traffic to wireless devices.

    In other words, my laptop (wireless) can surf the web, but can't connect to my server on the LAN by IP or hostname, and can't connect to the router via

    This is NOT solved by a reboot, but responds to disabling the wireless in software and then re-enabling it.

    Has anyone else run into this? I'm running 1.19, default settings on wireless, standard 10mW power.


  2. JPorter

    JPorter LI Guru Member

    Also, traffic from the LAN side of the box to the wireless side is way slower than it should be.

    Anybody? Do I have a fried router? What do you think?
  3. JPorter

    JPorter LI Guru Member

    Anybody out there?
  4. LLigetfa

    LLigetfa LI Guru Member

    Have you tried clearing NVRAM and hand-jobbing in all the settings?
  5. JPorter

    JPorter LI Guru Member

    I haven't tried that yet... what's the procedure?
  6. FRiC

    FRiC LI Guru Member

    I have a WHR-HP-G54 running 1.19/Victek and don't seem to have any problems. It's serving about 40 wired and wireless users behind a 2/2Mbps commercial G.SHDSL line. The site normally uses a $1000 UTM but they've been having problems, so I temporarily replaced it with a $50 home router and it's working much better for them. :)
  7. jsmiddleton4

    jsmiddleton4 Network Guru Member

    Now THAT'S an endorsement!
  8. Kiwi8

    Kiwi8 LI Guru Member

    LOL $950 saved! :biggrin:

Share This Page