1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Odd WRT54G/Vonage RT31P2 throughput problem

Discussion in 'DD-WRT Firmware' started by steve_hocking, Sep 18, 2006.

  1. Hi there,

    I'm sorry if this is in the wrong place and if it is I'd be more than happy to move it. However I'm experiencing a couple of odd problems and I'm sure that they're related.

    I have just bought a RT31P2 from Vonage. I already had a WRT54G (v4 I think) that I had flashed to dd-wrt v23sp1. So I was looking at setting my network up like this:

    Cable Modem (NTL:Home 100) <-> WRT54G <-> RT31P2

    However when I do this if I use the phone the WRT54G becomes unresponsive to computers connected via either Wireless or Ethernet. I swapped the networking around to this:

    Cable Modem <-> RT31P2 <-> WRT54G

    And this allows me to use the internet at the same time as making a call.

    However to put more fuel on the fire I tested the speed of my connection (I'm on 10Mbps down and 512Kbps up). Wireless the best I get is 1Mbps down, though I do get close to full up speed. When connected to any of the devices via ethernet I get 8Mbps+ down. There are some other wireless networks in the area, and mine shares a channel with the weakest signal.

    Has anyone else experienced these kind of problems, and did you solve them?

    Thanks, Steve

    Edit: not v4, v2.2
  2. gp33

    gp33 Guest

    I am having a problem also, the power light(more than a few times an hour) starts to blink and the cisco light at that time stops glowing.....as this is happening, I loose internet/network connection, and my 2 wireless computers that are connected to the network have ip address conflicts?????
    Do you have any idea what is going on with this???
  3. Disman_ca

    Disman_ca Super Moderator Staff Member Member

    Thread has been moved to DD-WRT forum where you should receive a more specific response.

Share This Page