1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

openvpn , can't ping client subnet

Discussion in 'Tomato Firmware' started by hakowy, Feb 6, 2013.

  1. hakowy

    hakowy Networkin' Nut Member

    Hello, so i want to see PC1 and PC2, here is my configuration: [​IMG]

    Here is my config.openvpn (i have added recently push router 192.168.7.x ... and route 192.168.7.x ....)
    and client ccd:

    and my router's tomato config: [​IMG]
    [​IMG]

    What i have to do, to see 192.168.7.x subnet?
     
  2. kyrios

    kyrios Serious Server Member

    Can you ping the 1043ND router from WNDR router or PC behind WNDR?
     
  3. hakowy

    hakowy Networkin' Nut Member

    No, i can` t ping directly from netgear 1043nd lan ip(192.168.7.7), neither any computer in this subnet.
     
  4. kyrios

    kyrios Serious Server Member

    If you can't ping 1043ND (client router) both from WNR router (OpenVPN server) nor PC behind WNR,
    then there's probem with key thingy.

    In latest OpenVPN 2.3.0 (latest Shibby and Toastman), I do not have to add any command in Custom Configuration,
    both at server router and client router.

    2 days ago I successfully tested using both TUN and TAP interface.
    Server using Shibby 105.2 (RT-N16), client using Toastman 0501.2 (E4200v1).
    Custom Configuration: I just leave it empty both for server and client.

    Give us the sreenshot of Status of server side?
    When connected, client will be shown over there.
    Also show us your client configuration.
     
  5. hakowy

    hakowy Networkin' Nut Member

    yes i cannot ping lan ip of wr1043nd(192.168.7.7) i can only ping its openvpn ip(10.9.0.10).

    Here is my updated router's config:
    [​IMG]

    and wr1043nd client config (client is using gargoyle fw), and wr1043nd takes internet from mifi 3g modem(wifi repeater is disabled):
    http://pastebin.com/kVmtX06N

    and here is openvpn server status(client 10 is wr1043nd), client1 is my pc connected to this vpn:
    [​IMG]

    i have also other wr1043nd as server, and when i connect to it through pc i can normally ping its local ip, dont have any problems, but it is set as server not client.
     
  6. kyrios

    kyrios Serious Server Member

    I think you may safely remove this line from server's Custom Configuration.
    route 192.168.7.0 255.255.255.0

    About Gargoyle as OpenVPN client, I'm sorry I never have had gargoyle set as it.
    Maybe others can help you with client config of Gargoyle.

    client1 (your PC) I assume it's not behind Gargoyle, right?
    If yes (behind Gargoyle= same subnet), do not Install OpenVPN into your PC.
    Coz I saw you install OpenVPN with into your PC.
     

Share This Page