OpenVPN - TCP 443 set up

Discussion in 'Tomato Firmware' started by Chingyul, Jun 4, 2011.

  1. Chingyul

    Chingyul Networkin' Nut Member

    Hey,

    This place has been a great help setting up Tomato and OpenVPN. Registered to ask a question though.

    I've set up OpenVPN with a TAP/UDP set up, and it's working fine. However, since Tomato supports running 2 servers, I figured I'd setup a TCP 443 server in the case where there's port restrictions.

    I essentially took my UDP setup ( http://www.linksysinfo.org/forums/showthread.php?t=64765 ), and changed the protocol and port, but I can't connect.

    This is my client for the UDP.

    dev tap
    proto udp-client
    dev-node OpenVPN
    remote XXX.dyndns.org 443
    tls-client
    keepalive 15 120
    verb 3
    mute-replay-warnings
    ca ca.crt
    cert XXX.crt
    key XXX.key
    tls-auth ta.key 1
    ns-cert-type server
    cipher AES-256-CBC
    pull
    nobind
    show-net-up
    comp-lzo

    When I try to connect, it times out.

    I'm using the same keys for both servers, but I don't think that should be an issue.
    Am I missing something obvious here?
     
  2. Chingyul

    Chingyul Networkin' Nut Member

    Can I bump this?
    Suggestions?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice