OSPF or RIP, the router stop to route

Discussion in 'Sveasoft Firmware' started by PacoSS, Nov 2, 2004.

  1. PacoSS

    PacoSS Network Guru Member

    Satori 4.0G has 3 states of routing: Gateway, RIP and OSPF.

    When i put the AP in RIP or OSPF mode, it stop to act as a router to the WAN port.
    I have put a rule => but it doesn't work at all.

    All the AP's of my free wireless comunity are using OSPF so i need it in order to connect to the rest of the network, but I want to continue using my WRT54G as a Wireless router for my laptop.

    Any idea?
  2. Anonymous

    Anonymous Guest

    Turning on routing turns off NAT so you need to use valid IP addresses (for your network, not necessarily the Internet) for the LAN/wLAN device.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice