Overclocked WRT54G v3 - Wired works, but wireless doesn't

Discussion in 'Tomato Firmware' started by BaxterStockman, Apr 15, 2011.

  1. BaxterStockman

    BaxterStockman Networkin' Nut Member

    Hi all; thanks in advance for any help you are willing to offer.

    I've been digging around in this forum and others for ways to improve my WRT54G v3. Just a little while ago, I used accessed my router via telnet and executed the following commands:

    nvram set debug_clkfix=0
    nvram set clkfreq=240
    nvram commit
    reboot

    The unit rebooted fine, and for a little while I had wireless access. After a few minutes, pages stopped loading. I tried to telnet into the router again, with no luck. The Tomato GUI was also inaccessible.

    I reset the router, plugged in an ethernet cable, and checked telnet. The clkfreq had reverted to 216; however, I still can't access the web via wireless. inSSider 2.0 and the icon in the Windows tray shows that the router is broadcasting a signal just fine. I just can't open any pages!

    Any bright ideas about what might have happened, and what (if anything) I can do about it?

    Thanks!
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice