1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Planet WAP-4000 and Access Point Mode

Discussion in 'Other Linksys Equipment' started by luiscar, Aug 11, 2005.

  1. luiscar

    luiscar Network Guru Member

    Dear all,

    I have a Linksys WRT54GS with firmware upgraded to sveasoft alchemy pre7. The route goes perfect working as AP when I connect any other WRT54Gx (working in client mode) to it.

    Nevertheless, when I try to connecte the Planet WAP-4000, at first it works and gives back all pings after some pings it does not give anything, then it goes back and finally hangs completely until I disconnect the Planet.

    Any ideas about why this is happening?
     
  2. 4Access

    4Access Network Guru Member

    No real ideas but how come you're still using a beta firmware when the stable version is available?
     

Share This Page