Plastic Tray Supporting WRT54G V2 Circuit Board

Discussion in 'Cisco/Linksys Wireless Routers' started by BobCochran, Apr 26, 2005.

  1. BobCochran

    BobCochran Network Guru Member

    After looking much more closely at the autopsy photos of the WRT54G v2 board, I can see that the board is actually attached to a plastic tray via four oval holes, two on each side of the board. It further looks like the plastic tray can be screwed to something -- like perhaps brass motherboard standoffs that have been screwed into sheet metal holes provided for the purpose. I might be able to recycle an old ATX computer case, cutting out a part of the motherboard tray and using that to help support the WRT board in a waterproof enclosure.

    Thanks

    Bob
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice