1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Please help!!! E3000

Discussion in 'Tomato Firmware' started by Tippmann, Mar 19, 2012.

  1. Tippmann

    Tippmann Networkin' Nut Member

    Hi guys i been using tomato for the past 3 months now and updating it every new toastman release but now when i was about to update it to latest version my power went off and my router is kind of bricked . I said king because i can ping it but that's it nothing also no telnet no anything is a E3000 please i wish i cold have access to at least telnet so i can upgrade the FW by tftp. please help me

    thanks in advance
     
  2. Tippmann

    Tippmann Networkin' Nut Member

    hard reset did not work done it like 8 times now
     
  3. Rocky Grim

    Rocky Grim Networkin' Nut Member

    I bricked my Netgear WNR3500L the other day. Same type of situation. I am using Windows 7. All I did was enable TFTP client from "Windows Features". This allowed me to TFTP back to the Netgear stock firmware. The guide I fallowed for the 3500L said you either needed a JTAG cable or to open the router and short a spot on the board. I did open it and shorted the to points on the board. I don't know if it can be done without doing that or not. I hope this will help.
     
    Tippmann likes this.
  4. Tippmann

    Tippmann Networkin' Nut Member

    thanks this was my solution
     
  5. Rocky Grim

    Rocky Grim Networkin' Nut Member

    NP glad it worked out for ya.
     
    Tippmann likes this.

Share This Page