policy routing

Discussion in 'Tomato Firmware' started by rs232, Oct 27, 2010.

  1. rs232

    rs232 Network Guru Member

    Hello, is it possible to use policy routing using tomato?

    What I'm looking for is: change destination IP (of the default-gateway) based on source IP & destination port (I have 2 internet connections).

    Also nice to have use the QoS layer 7 information rather than IP/port to affect the policy.


    Thanks
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice