1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Port 3 & 4 Trunk on WRT54GS v1.1 (DD-WRT 2.3SP2)

Discussion in 'DD-WRT Firmware' started by TheLastUnicorn, Nov 19, 2006.

  1. TheLastUnicorn

    TheLastUnicorn Network Guru Member

    Hello all,

    as I didn't find anything in the forum archive I hope for an answer here. I use a WRT54GS v1.1 with DD-WRT 2.3SP2 together with a HP ProCurve Switch 2626. For better throughput I would like to connect router and switch twice by creating a trunk consisting of the router's port 3 and 4 and two switch ports. I thought everything would work if I activated the link aggregation button in the DD-WRT's Menu Setup-->VLAN (port 3 & 4 --> Trunk) and the switch as well. However it doesn't work!!! I am sure that the switch configuration is ok since I already have a link aggregation running together with another HP ProCurve switch. So I think something is wrong with the router configuration, but I have no idea yet ...

    Perhaps somebody out there could help me with that ...

    Best regards,

  2. madamada

    madamada Guest

    Link Aggregation


    I have some issue here.
    Anybody have solution for it ?

  3. HennieM

    HennieM Network Guru Member

Share This Page