Port Forwarding BEFW11S4

Discussion in 'General Discussion' started by Anonymous, Aug 14, 2005.

  1. Anonymous

    Anonymous Guest

    Can someone PLEASE explain to me how to open the ports on my Linksys BEFW11S4 router. I have the v.latest firmware update.
    Below is a screen shot of what I see.


    If anyone could please tell me how I do it?
    IS it just possible to just open the ports, rather than just allow specific applications?
    As I've no idea what I should call each individual application...

    Please help, this is greatly restricting my net udsage, thank you.
  2. 4Access

    4Access Network Guru Member

    Application = Just a description so you remember what the port forwarding is for.

    Start To & End = the range of ports you want forwarded. If you only want to forward a single port then enter the same number into both boxes.

    Protocol = Specify whether you want to forward TCP or UDP traffic.

    IP Address = The IP address of the PC on your LAN you want the traffic forwarded to.

    Enable = I'll let you figure this one out on your own. ;)

    PortForward.com might also be worth a look.

    Good luck.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice