1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Port forwarding question

Discussion in 'DD-WRT Firmware' started by meall, Jun 16, 2007.

  1. meall

    meall LI Guru Member

    Hi,

    My ISP is blocking FTP ports (21/20) , but I want to enable FTP on a server in my house to the outside world.

    What I did is very simple, in the port forwaring pane, I created 2 entries:

    port 2100 ===> port 21 on my server internal IP
    port 2099 ===> port 20 on my server internal IP

    In my mind, this should work just fine. When I connect FTP from an outside computer, I get a message saying connected to, then I receive another one saying connection closed by host.

    Any idea what's wrong?

    I know FTP is a tricky protocol, but still, I'm sure there's a way to make this work.

    Thanks
     
  2. meall

    meall LI Guru Member

    Hi,

    I think I found my problem. I had a port triggering enabled for the sames ports. Maybe from a previous test.

    Disabling that makes the port forwarding running as I wanted.

    Not sure what does port triggering vs port forwarding, but it does not look to be the same as expected.

    Thanks for reading.
     

Share This Page